Firewall Configuration

All of our installation, except for the PBX in a Flash, comes with apf firewall pre-installed.  The number of port open may or may not be sufficient for your requirement.  You are free to change them.  You may also replace it with other firewall.  You may do so since you will be granted a root access.

Please note that it is your responsibility to keep your server secure.

Here are some information about apf http://www.rfxn.com/projects/advanced-policy-firewall/

For  PBX in a Flash, please refer to "Firewall Configuration" in the PBX in a Flash specific FAQ.

UPDATE:

As of 1/10/2011 any new server and rebuild server will have combination centos iptables firewall and fail2ban

Дали Ви помогна овој одговор?

 Испечати

Исто така прочитајте

High CPU usage due to whois process

We have seen some of the PBX experience high CPU usage due to spinning whois process. If you...

Dahdi Detected time shift in /var/log/message

If you find a lot of message " dahdi detected time shift" in /var/log/message, please...

Change Timezone

When we provisioned our PBX,  we will provision it to USA Pacific Daylight Timezone....

I Cannot access my PBX Server, it is down

This is for when you cannot even ssh to your PBX IP or you keep getting disconnected. If you're...

Issue with IAX Call rejected, CallToken

If you have problem connecting through IAX protocol, please check if you see " Call...