Firewall Configuration

All of our installation, except for the PBX in a Flash, comes with apf firewall pre-installed.  The number of port open may or may not be sufficient for your requirement.  You are free to change them.  You may also replace it with other firewall.  You may do so since you will be granted a root access.

Please note that it is your responsibility to keep your server secure.

Here are some information about apf http://www.rfxn.com/projects/advanced-policy-firewall/

For  PBX in a Flash, please refer to "Firewall Configuration" in the PBX in a Flash specific FAQ.

UPDATE:

As of 1/10/2011 any new server and rebuild server will have combination centos iptables firewall and fail2ban

Je li Vam ovaj odgovor pomogao?

 Ispiši članak

Također pročitajte

How to activate Affiliates program

Activate your affiliate account today to: Receive an initial bonus deposit in your affiliate...

XEN ERROR: 4GB SEG FIXUP

If you update or install new packages,  please make sure that you check /var/log/message....

Call Quality Troubleshooting

In the case that you are experiencing bad call quality please consider the following suggestions....

Login

All server are setup with root access ssh.  Login information to use with the ssh is sent in...

I Cannot access my PBX Server, it is down

This is for when you cannot even ssh to your PBX IP or you keep getting disconnected. If you're...