I'm getting error about no ETH0/ETH1

This newer system has different network location so as suggested when you first SSH to your new PBX, you need to edit /etc/pbx/.statusnet

Type below:

nano /etc/pbx/.statusnet

and change to below

ALTETH="1"
NEWETH="venet0:0"

Hasznosnak találta ezt a választ?

 Kinyomtatja ezt a cikket

Olvassa el is

How to access console of your server

IMPORTANT: - Console access may require you to use browser that support TLS 1.0/1.1, like Chrome...

How to access web control panel

NOTE: Console access may require you to use Chrome browser in Private Window. And if issues, try...

I cannot SSH to new server after the move

This usually happens on older system like "PBX in a Flash SILVER 1.7 (dahdi, asterisk 1.4)" so...

How to increase my KVM account disk space

If you have a KVM plan, by default, the space is 20GB, if you get bigger space, you will need to...

My iptables show error on new system

You just need to SSH or access via noVNC Console and type 2 commands below:mkdir...